Table of Contents
Advertisement
1.
INSTALLATION
Use one of the supplied 3M pads to attach the gyro to your plane firmly. For best performance the gyro should be mounted
as close to the C.G. as possible, and the housing edges must be aligned exactly parallel to all three rotation axis of the
plane. The gyro can be attached flat or upright, and even upside down, however, you have to ensure the arrow on the
sticker always point to the heading direction, otherwise the gyro will not work normally when operating it in Trainer mode,
Auto-Level and Auto-Hover modes.
Flat:
face up, socket pointing to rear.
Upright:
button up, socket pointing to rear.
CAUTION
1.
You need only one piece of the tapes each time, a soft or thick mounting may probably impact the
performance of the gyro.
2.
Never use the hot-melt glue or nylon ties to fix the gyro onto the plane!
3.
The gyro is a sensing device, please make enough space around it and keep as far away from other
electronic devices or wires as possible.
support@hobbyeagle.com
Flat Inverted:
face down, socket pointing to rear.
Upright Inverted:
button down, socket pointing to rear.
2
Hide quick links:
Advertisement
Table of Contents
