Travel Limiting - Eagle A3 Pro Instruction Manual

at [OUT1] is always the first one selected after you entering the procedure.
When the desired servo has been chosen, move and hold the aileron stick into one direction to change the center position
for it, when it reaches the desired position release the aileron stick and wait for about 2 seconds until the LED turns solid
violet, the current servo position will be saved as the new neutral automatically. While moving the servo, the LED will blink
blue and a rapid red blinking indicates that the servo has reached the maximum center position allowed. The new neutral
position of current servo will also be saved when you switching to the next servo.
After you have finished the setting, just flip the flight mode switch or long press the button again to exit.
7.2.

TRAVEL LIMITING

This function allows you to adjust the travel limits of the servos using the transmitter. It will be more convenient and more
intuitive. After entering this procedure, move the elevator stick up or down to select one of the servos connected at [OUT1]
to [OUT3]. The current servo will indicate its selection to you by a short up and down move. By default, the servo connected
at [OUT1] is always the first one selected after you entering the procedure.
When the desired servo has been chosen, move and hold the aileron stick into one direction to move the servo until it
reaches the maximum allowed throw without any binding or stall, then release the aileron stick and wait for about 2 seconds
until the LED turns solid violet, the current position will be saved as the new travel limit automatically. Then move the servo
to the opposite direction and wait until also this position gets stored. While moving the servo, the LED will blink blue and a
rapid red blinking indicates that the servo has reached the maximum allowed (i.e.150%). The new travel limit of current
servo will also be saved when you switching to the next servo.
After you have finished the setting, just flip the flight mode switch or long press the button again to exit.
support@hobbyeagle.com 8