Maintaining the Server
c) Push the tray into the slot until it touches the backplane, and then close the ejector lever to lock the drive in place.
Figure 20: Replacing a Drive in a Drive Tray
1
Ejector lever
2
Release button
Replacing Front-Loading NVMe SSDs
This section is for replacing 2.5-inch or 3.5-inch form-factor NVMe solid-state drives (SSDs) in front-panel
drive bays.
Replacing Front-Loading NVMe SSDs
3
Drive tray screws (two on each side)
4
Drive removed from drive tray
Cisco UCS C240 M5 Server Installation and Service Guide
53