Gpu Front Support Bracket Inserted To Securing Latch On Air Baffle - Cisco UCS C240 M5 Installation And Service Manual

GPU Card Installation
Caution Do not reverse the straight power cable. Connect the black connector on the cable to the black connector
on the GPU card. Connect the white connector on the cable to the white connector on the PCIe riser.
c) Close the card-tab retainer over the end of the card.
d) Swing the hinged securing plate closed on the bottom of the riser. Ensure that the clip on the plate clicks into the
locked position.
e) Position the PCIe riser over its socket on the motherboard and over the chassis alignment channels.
f) Carefully push down on both ends of the PCIe riser to fully engage its connector with the sockets on the motherboard.
At the same time, align the GPU front support bracket (on the front end of the GPU card) with the securing latch that
is on the server's air baffle.
Step 6 Insert the GPU front support bracket into the latch that is on the air baffle:
a) Pinch the latch release tab and hinge the latch toward the front of the server.
b) Hinge the latch back down so that its lip closes over the edge of the GPU front support bracket.
c) Ensure that the latch release tab clicks and locks the latch in place.
Figure 55: GPU Front Support Bracket Inserted to Securing latch on Air Baffle
1 Front end of GPU card
GPU front support bracket
2
Installing a Double-Wide GPU Card
3 Lip on securing latch
Securing latch release tab
4
Cisco UCS C240 M5 Server Installation and Service Guide
153