Removing The Top Cover - Cisco UCS C240 M5 Installation And Service Manual

Removing the Server Top Cover
a) If the cover latch is locked, use a screwdriver to turn the lock 90-degrees counterclockwise to unlock it.
b) Lift on the end of the latch that has the green finger grip. The cover is pushed back to the open position as you lift
the latch.
c) Lift the top cover straight up from the server and set it aside.
Step 2
Replace the top cover:
a) With the latch in the fully open position, place the cover on top of the server about one-half inch (1.27 cm) behind
the lip of the front cover panel. The opening in the latch should fit over the peg that sticks up from the fan tray.
b) Press the cover latch down to the closed position. The cover is pushed forward to the closed position as you push
down the latch.
c) If desired, lock the latch by using a screwdriver to turn the lock 90-degrees clockwise.
Figure 14: Removing the Top Cover
Cover latch
1
2 Cover lock
Cisco UCS C240 M5 Server Installation and Service Guide
42
Serial number label location
3
Maintaining the Server