AirSep NEWLIFE elite Patient Manual page 8

Oxygen monitor, air outlet, dual flow, and pediatric flow options
Hide thumbs Also See for NEWLIFE elite:
Table of Contents

Advertisement

Electrical shock hazard. Disconnect the power cord from the electric outlet before you clean the unit to
prevent accidental electrical shock and burn hazard. Only your Equipment Provider or a qualified service
technician should remove the covers or service the unit.
Do not leave a nasal cannula under bed coverings or chair cushions. If the unit is turned on but not in use,
the oxygen will make the material flammable. Set the I/0 power switch to the 0 (off) position when the
NewLife Elite unit is not in use.
Do not use extension cords with this unit or connect too many plugs into the same electrical outlet. The use
of extension cords could adversely affect the performance of the device. Too many plugs in one outlet can
result in an overload to the electrical panel causing the breaker/fuse to activate or fire if the breaker or fuse
fails to operate.
Use only voltage specified on back panel label.
Do not use your oxygen concentrator in the presence of flammable gases. This can result in rapid burning
causing property damage, bodily injuries or death.
Care should be taken to prevent NewLife Elite from getting wet or allowing water to enter the unit. This can
cause the unit to malfunction or shut down, and cause an increased risk for electrical shock or burns.
Do not use liquid directly on the unit. A list of undesirable chemical agents includes but is not limited to
the following: alcohol and alcohol-based products, concentrated chlorine-based products (ethylene
chloride), and oil-based products (Pine-Sol , Lestoil ). These are NOT to be used to clean the plastic
housing on NewLife Elite, as they can damage the unit s plastic.
2
MN078-1 Rev F
8/12

Advertisement

Table of Contents
loading

Table of Contents