Re-Start After Fault Clearance; Maintenance; Cleaning - ELGO Electronic Z25 Operating Manual

10.3 Re-start after Fault Clearance

After the fault clearance:
1. Reset the emergency stop mechanism if necessary
2. Reset the error report at the super-ordinate system if necessary.
3. Ensure that there are no persons in the danger area.
4. Follow the instructions from chapter 5.
WARNING!
Danger of injury through non-conventional fault clearance!
Non-conventional fault clearance can lead to severe injuries and damage of property.
Therefore:



If components need to be replaced:




10.4 Maintenance

The device is maintenance-free.
WARNING!
Danger through non-conventional maintenance!
Non-conventional maintenance can lead to severe injuries and damage of property.
Therefore:
Maintenance works may only be completed by staff that has been authorized and trained by the operator.

10.5 Cleaning

WARNING!
The device can only be cleaned with a damp cloth, do not use aggressive cleanser!
Any work to clear the faults may only be performed by sufficiently qualified staff
Arrange enough space before starting the works
Make sure that the mounting area is clean and tidy. Loose components and tools are sources of accidents.
Pay attention to a correct installation of the spare parts.
Reinstall all the fixing elements properly
Before turning on the device, ensure that all covers and safety equipment is installed correctly and functions
properly
Disturbances, Maintenance, Cleaning
- 17 -