Axis Q1775 User Manual page 11

AXIS Q17 Network Camera Series
Setup
7. From the list of triggers, select Detectors and then select Tampering.
8. From the list of actions, select Send Notification and then select a recipient from the list or click New Recipient
to create a new recipient.
9. Enter Subject and Message for the email.
10. Click Ok.
How to automatically zoom in on a specific area with gatekeeper
This example explains how to use the gatekeeper functionality to make the camera zoom in automatically on the license plate of a
car that passes through a gate. When the car has passed, the camera zooms out to the home position.
Create a motion detection profile:
1. Go to Settings > Apps and open AXIS Video Motion Detection.
2. Create a profile that covers the entrance of the gate and then save the profile.
Create the preset positions:
3. Go to Settings > PTZ > Preset positions.
4. Create the home position that includes the entrance of the gate.
5. Create the zoomed-in preset position so that it covers the area in the image where you assume that the license plate
will appear.
Create an action rule:
6. Go to Settings > System > Events and add an action rule.
7. Name the action rule Gatekeeper.
8. From the trigger list, select Applications and then select the previously created motion detection profile.
9. From the action list, select the previously created preset position.
10. Click OK.
How to record video when a PIR detector senses motion
This example explains how to connect an Axis PIR detector to the camera, and set up the camera to start recording when the
detector senses motion.
Required hardware
• 3–wire cable (ground, power, I/O)
• Axis PIR detector
NOTICE TICE
NO NO TICE
Disconnect the camera from power before connecting the wires. Reconnect to power after all connections are done.
Connect the wires to the camera's I/O connector
Note
For information on the I/O connector, see Connectors on page 17
1. Connect the ground wire to pin 1 (GND/-).
2. Connect the power wire to pin 2 (12V DC output).
11