Troubleshooting And Tips; Fujitsu Presenter Cannot Be Used. Why; Fujitsu Receiver Led Is Not On - Fujitsu Presenter IV Air Operating Manual

Troubleshooting and tips

If any of the following situations occur while using the Fujitsu Presenter, refer to the following Q&A
list for help:

Fujitsu Presenter cannot be used. Why?

Cause
Is the Fujitsu Presenter power on? ►
Is the Fujitsu Presenter in standby
mode?
Is the receiver plugged in?
Is there any interference with the
position of the receiver?
Is the distance between the
Fujitsu Presenter and the receiver
too close or too far?

Fujitsu receiver LED is not on

Cause
Is the power on?
Is the distance too far?
Has the synchronization of the
Fujitsu Presenter failed?
If any of the above solutions do not correct your problem or you have a question, visit our
i
website, "http://support.ts.fujitsu.com", for supplemental and/or updated information about
our product.
Fujitsu Technology Solutions
Troubleshooting
Make sure the Fujitsu Presenter power is on. If so, make
sure the batteries are correctly positioned in the Fujitsu
Presenter.
► If the Fujitsu Presenter has not been used for 60 seconds,
it will enter standby mode. Press any button of the Fujitsu
Presenter to re-activate it.
► Make sure the receiver is plugged-in correctly and the LED
is always on.
► Remove any obstacles in front of the receiver and make
sure you can clearly see the front of the receiver.
► Keep a distance between the Fujitsu Presenter and the
receiver of 1~5 meters.
Troubleshooting
► Make sure the computer power is on and the Fujitsu
Presenter is not in the Power Off mode.
► If the Fujitsu Presenter is too far away, the receiver cannot
detect it. Maintain a distance between the Fujitsu
Presenter and the receiver of 1~5 meters.
► Refer to section "Synchronizing the Fujitsu receiver with
the computer" for synchronization information.
Troubleshooting and tips
11