Remote Control; Resetting The Main Unit; Switching The Speaker Impedance; Changing The Tv Format Setting - Pioneer VSX-1015-K Operating Instructions Manual

Additional information

Remote control

Symptom
Cannot be remote controlled.
Other components can't be
operated with the system
remote.
The SR cable is connected, but
the connected components can't
be operated with the remote.
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.

Resetting the main unit

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button, press and
hold the STANDBY/ON button for about three
seconds.
3 When you see RESET? appear in the display,
press ENTER.
OK? shows in the display.
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Cause
• The remote control batteries have worn out. • Replace the batteries (see Loading the batteries on
• Too far away or improper angle of operation. • Operate within 7 meters and a 30º angle of the remote
• There is an obstacle between the receiver
and the remote control.
• Strong light such as fluorescent light is
shining onto the unit's remote control sensor.
• Something is plugged into the CONTROL IN
jack.
• The preset code settings are wrong.
• The batteries wore out and the system
settings were cleared.
• The SR cable hasn't been connected
properly.
• The rest of the component connections
have not been made.
• The component you have hooked up is not a
Pioneer product.
Remedy
page 7).
sensor on the front panel (see Operating range of remote
control unit on page 30).
• Remove the obstacle or move to another place.
• Avoid exposing the remote sensor on the front panel to
direct light.
• Unplug the cable from the CONTROL IN jack and use
remote normally (see Operating other Pioneer components
on page 23).
• Input the correct preset code.
• Reset the proper system settings.
• Reinsert the SR cable, making sure it's connected to the
right jack (see Operating other Pioneer components on
page 23).
• Make sure an analog connection has been made
between the units.
• This feature only works with Pioneer products.

Switching the speaker impedance

We recommend using speakers of 8Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6Ω impedance rating.
• With the receiver in standby, press
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6Ω.
• SP 8 OHM – Use this setting if your speakers are
rated at 8Ω or more.

Changing the TV format setting

If the System Setup menu is not displayed correctly, it
may be that the TV system is set incorrectly for your
country or region.
• With the receiver in standby, press
ON while holding down the SIGNAL SELECT button.
The display shows the new setting (PAL or NTSC).
12
STANDBY/
STANDBY/
73
En