Remote Control; Loading Ba Tere S Cshndunisstetusivansb I Ckocssget Taste Aatenesaa Adeoicaeraadecaisonen Easeeaarattaccen Aialaites; Operations Sarc Cated Sucsosaace An Sset Coe Est Ict Vk Seat Aseteanuepu Eau Sde Tthe Saticsaaieees Dapectinhataetitoipsalss - Pioneer VSX-9700S Operating Instructions Manual

REMOTE CONTROL
LOADING BATTERIES
1. Open the battery compartment cover on the rear of the remote
control unit. The cover should open easily if you slide it in the
direction of the arrow while pressing on it with your thumb.
2. Take out the four supptied batteries (LRO3/AM-4), and insert them
into the battery compartment in accordance with the indications
in the compartment.
3. Close the cover of the battery compartment.
Cover
Reset button
Incorrect use of batteries may lead to leakage or rupture.
Always be sure to follow these guidelines:
A.
Always insert batteries into the battery compartment correctly matching
the positive + and negative ~ polarities, as indicated inside the
compartment.
B.
Never mix new and used batteries.
Cc.
Batteries of the same size may have different voltages, depending on
their type. Do not mix different type of batteries.
REMOTE CONTROL RANGE
When operating the remote contro! unit, point the front of the unit at
the front panel of the receiver. The remote control unit may be used
within a range of about 7 meters (23 feet) from the remote sensor,
within angles of up to about 30 degrees.
Performance of the remote control unit is adversely affected in the
presence of strong fluorescent light. Keep such lights away, specially
from the sensor window.
S</
FF 7m (23 feet)
Battery Replacement
When the batteries have run out, the transmit indicator will not illuminate
even when a key is pressed. Be sure to replace the batteries as soon
as possible. As the programmed functions will be retained in memory
only as long as batteries are inserted, remove the old batteries only if
they can be replaced by new ones immediately.
Also, be sure to always use the specified batteries. [size "'AAA"'
{LRO3/AM-4) alkaline batteries]
NOTE:
When no batteries are inserted, the programmed memory contents will
be erased after 30 to 60 minutes.
OPERATION :
TRANSMII
@) TRANSMIT mode selector switch 2 indicator
AUDIO: @ LEARN selector @ TRANSMIT mode
Select this position for remote control operation of audio equipment such
as a CD player, tape deck, turntable or receiver.
VIDEO:
Select this position for remote control operation of video equipment such
as a Video disc player (LD player), VCR or TV.
AUX:
The AUX mode is provided for programming extra commands in case
you have filled up all the keys in the VIDEO and AUDIO modes. If you
do not program any new commands, then only the receiver amplifier
keys will operate in this mode. You may wish to use this mode to assign
extra commands for a second VCR, tape deck etc.
© Keys 1 to 12 are used as station keys for TUNER and TV. (In the CD
and VDP modes 1 to 10 are number keys, 11 is the MEMORY, and
12 is the CLEAR key.)
® The function keys can be used in all modes.
* In the AUX mode, only the receiver keys transmit. Use after
programming into memory the commands of your other remote
control unit.
@) TRANSMIT indicator
This light flashes when remote control signals are being sent.
@ LEARN selector switch
For Pioneer components set this switch to SR RECALL. Set to LEARN
when programming the memory, and set to USE when using the
memory. (More about LEARN switch on page 42.)
36
<ARB1234>
® PIONEER
a