Switching The Hdmi Output (Vsx-33 Only); Using The Web Control Function; Checking Your System Settings; Resetting The System - Pioneer Elite VSX-33 Operating Instructions Manual

08 Using other functions
Switching the HDMI output
(VSX-33 only)
Set which terminal to use when outputting video and
audio signals from the HDMI output terminals.
The HDMI OUT1 terminal is compatible with the Control
with HDMI function.
RECEIVER
• Press
Please wait a while when Please wait ... is displayed.
The output switches among HDMI OUT ALL, HDMI OUT
1 and HDMI OUT 2 each time the button is pressed.

Using the Web Control function

The receiver can be operated using a browser from a
computer connected on the same LAN as the receiver.
1 Turn on the computer and launch the Internet
browser.
2 In the address bar on the browser, enter the IP
address assigned to this receiver.
For example, if the IP address of this receiver is
"192.168.0.2", enter "http://192.168.0.2/".
When the connection is made with the receiver, a Top
Menu will be displayed.
This receiver's IP address can be found in the 'IP address,
Proxy' menu (page 85).
3 Once the Top Menu is displayed, click the button for
the zone you want to operate.
4 Operate from the screen for the individual zone.
• Even when the receiver is in the standby mode, it can
be turned on using the Web Control function. For
details, see Network Standby on page 86.
Web Control
Main ZONE
POWER
INPUT SELECT
LISTENING MODE
AUTO SURR/ALC/
STREAM DIRECT
Note
1 • The synchronized amp mode is canceled when the HDMI output is switched. If you wish to use the synchronized amp mode, switch to HDMI
OUT 1, then select the synchronized amp mode on the TV using the TV's remote control.
• When the power is turned off then back on after switching the HDMI output, the input is set to a setting between HDMI1 and HDMI3, or BD.
2 The ZONE 3 input are only displayed for the VSX-33.
64
En
, then press HDMI OUT.
ZONE 2 ZONE 3
ON OFF VOLUME -60.0dB MUTE
DVD
STEREO
HOME STANDARD ADVANCED
STEREO
THX SURROUND SURROUND

Checking your system settings

Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press RECEIVER
system settings.
The front panel display shows each of the following
settings for three seconds each: Input function,
Sampling Frequency, MCACC preset, ZONE 2 input,
ZONE 3 input
1
2 When you're finished, press STATUS again to
switch off the display.

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory device from
the receiver beforehand.
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel,
press  STANDBY/ON.
The display shows RESET  NO .
Select 'RESET' using PRESET /, then press
3
ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Top Menu
, then press STATUS to check the
2
and HDMI OUT.