Speaker Impedance - Pioneer VSX-D908TX Operating Instructions Manual

7 Speaker terminals
1 Twist exposed wire
strands together.
10 mm

Speaker impedance

You can change the speaker impedance to suit the kind of speakers you have in your home system but we
recommend using speakers with an impedance of 8 -16
8 impedance speakers, you need to change the impedance setting.
w STANDBY/ON
VSX-D938TX
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
STANDBY/ON
DSP
STANDBY MODE STEREO
/DTS
THX CINEMA ADVANCED STANDARD
5-CHANNEL EQUAL POWER OUTPUT
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
PHONES
SPEAKERS
2 Loosen speaker
terminal and insert
exposed wire.
First turn the receiver off, then press the power button
while holding down the SPEAKERS button.
Digital S
Choose the impedance setting by pressing the SPEAKERS button again.
You can choose the 8 -16
MPEG
SIGNAL
SELECT
ANALOG SP A
EXTERNAL
DECODER IN DIRECT LOUDNESS MIDN
SPEAKERS – BASS + –
To check which impedance the amplifier is set to hold down
the SPEAKERS button for 2-3 seconds. You willl get a display
like the one shown below right telling you the speaker
impedance setting.
SIGNAL
SELECT
ANALOG SP A
(This display indicates a 6 -less
than 8 impedance setting)
Connecting Your Equipment
3 Tighten terminal.
(the default setting). If you are using 6 -less than
setting or the 6 -8
VOLUME
(This display indicates an 6 -less than
dB
8 impedance setting)
SIGNAL
VOLUME
SELECT
ANALOG SP A
dB or
(This display indicates an 8 -16
impedance setting)
setting.
VOLUME
dB
15