Speaker Terminals; Speaker Impedance - Pioneer VSX-908RDS-G Operating Instruction

7 Speaker terminals

1 Twist exposed wire
strands together.
10 mm

Speaker impedance

You can change the speaker impedance to suit the kind of speakers you have in your home system. We
recommend, however, using speakers with an impedance of 8 -16
less than 8 impedance speakers, you need to change the impedance setting.
STANDBY/ON
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
STANDBY/ON
DSP
STANDBY MODE STEREO
/DTS
THX CINEMA ADVANCED STANDARD
—OFF _ON MPEG
5-CHANNEL EQUAL POWER OUTPUT EXTERNAL
DECODER IN DIRECT LOUDNESS MIDNIGHT
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
PHONES
SPEAKERS – BASS +
Main power SPEAKERS
button
2 Loosen speaker terminal
and insert exposed wire.
Before operating the receiver, be sure to press the main power
button on the front panel to turn the power ON (_ ).
First turn the receiver off (Standby mode), then press the
STANDBY/ON button while holding down the
SPEAKERS button.
Choose the impedance setting by pressing the SPEAKERS button again.
DIGITAL SIGNAL
NR SELECT RF ATT CLASS FM/
You can choose the 8
TAPE 2 CHARACTER
– TREBLE + INPUT ATT MONITOR /SEARCH MEM
SIGNAL
SELECT
ANALOG SP A
To check which impedance the amp is set to, hold down the
SPEAKERS button for 2-3 seconds. You will get a display like
the one shown below telling you the speaker impedance
setting.
SIGNAL
SELECT
A
ANALOG SP
(This display indicates an 8 -16
impedance setting.)
Connecting Your Equipment
3 Tighten terminal.
(the default setting). If you are using 6
-16 setting or the 6 -less than 8
VOLUME
(This display indicates an 6 -less than
dB
8 impedance setting)
SIGNAL
VOLUME
SELECT
A
ANALOG SP
dB or
(This display indicates an 6 -less
than 8 impedance setting.)
setting.
VOLUME
dB
15