Pioneer VSX-D908TX Operating Instructions Manual page 56

Remote Control of Other Components
Learning mode: Programming signals from other remote controls
If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this function to program in signals from the remote control(s) of your other component(s). This
operation can also be used after recalling a preset code to program additional operations not covered in the
preset codes.
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TV CONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3
- + -
TUNING STATION
1 ¡ 4
-
CHANNEL
1 2 3
3
4 5 6
7 8 9
+10 0 DISC
RF ATT
TV
TV VOL TV CONTROL VOLUME
TV FUNC
EFFECT
MENU MUTE
/CH SEL
FUNCTION
ENTER
2/dts
SYSTEM
THX ADVANCED STANDARD
SETUP
2,3
REMOTE
MIDNIGHT DSP STEREO
SETUP
DIGITAL NR
AV PREPROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
VSX-D938TX
56
1
Turn on your TV and the receiver.
Î
1
Make sure your TV is set to the appropriate video input (e.g. VIDEO
1).
4
2
8
Press REMOTE SETUP.
+
¢
The REMOTE SETUP menu appears on your TV screen.
+
DISPLAY
3
Press REMOTE SETUP and
SIGNAL
SELECT
select the LEARNING SETUP mode.
MPEG
All the MULTI CONTROL buttons (except the TUNER button) start
to blink.
To cancel LEARNING SETUP mode
Press REMOTE SETUP.
4
Press MULTI CONTROL for the component you want
to control.
Each button can be set to control one of the following
components.
The selected button continues to blink.
Select Remote
Setup Mode
Remote SETUP+1
Preset Recall
Remote SETUP+2
Learning
Remote SETUP+3
Multi-Operation
Remote SETUP+4
Direct Function
at the same time to
2
Learning Setup
1Place both commanders
pointing at each other.
2Select the item from
the Multi-control
buttons that should be
duplicated. (ex. DVD)
Multi-control button
starts blinking.
EXIT=Remote setup
Learning Setup
3Press one button that
should be duplicated.
4Multi-Contorol button
lights up.
5Press one button on the
original commander, and
hold 2 to 10 seconds.
6Repeat this process to
duplicate next command.
EXIT=Remote setup