Using Other Functions; Recording From Audio Components - Pioneer VSX-D908TX Operating Instructions Manual

Using Other Functions

Recording from Audio Components

The following explanations show you how to record an analog audio signal with the component you connected
to the MD/TAPE 1 or TAPE 2 MONITOR jacks. Note that you cannot record an component that is only
connected digitally. If you want to record from a digital component, it must be connected in an analog manner as
well. If you want to record a digital signal, see the next page.
The receiver's volume, channel level, tone (BASS, TREBLE, and LOUDNESS), and surround effects
have no effect on the recorded signal and the EXTERNAL DECODER input cannot be recorded.
Î
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TV CONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
- + - +
TUNING STATION
1 ¡ 4 ¢
- +
CHANNEL
2 3
1
4 5 6
8 9
7
+10 0 DISC
RF ATT DISPLAY
TV
TV VOL VOLUME
TV CONTROL
TV FUNC
EFFECT
MENU MUTE
/CH SEL
FUNCTION
ENTER
SIGNAL
SELECT
2/dts
SYSTEM
THX ADVANCED STANDARD
SETUP
MPEG
REMOTE
MIDNIGHT DSP STEREO
SETUP
DIGITAL NR
AV PREPROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
VSX-D938TX
66
1
Select the source component and put the receiver in
that function. Remember, SIGNAL SELECT must be
set to analog.
1
Press the SIGNAL SELECT button on the remote control (or use the
button on the front panel) and choose ANALOG. Recording
DIGITAL or AC-3 RF (VSX-D938TX only) signals is not possible.
2
Start recording with a TAPE or MD (etc.).
3
Playback the source to be recorded.
Record monitor (TAPE 2 MONITOR)
If you connect a cassette deck (etc.) with a record monitor function to
the TAPE 2 MONITOR jacks, you can listen to the sound of the
recording as it is recorded.
Press TAPE 2 MONITOR to switch between the sound of
the recording (TAPE 2 indicator on) and the sound of the
source component (TAPE 2 indicator off).