Display - Pioneer VSX-D812 Operating Instructions Manual

05 Controls and displays

Display

1
1 SIGNAL SELECT indicators
Lights to indicate the type of input signal
assigned for the current component:
AUTO
Lights when AUTO signal select is on.
SB
Depending on the source, this lights
when a signal with surround back
channel encoding is detected.
DIGITAL
Lights when a digital audio signal is
detected.
2 DIGITAL
Lights when a Dolby Digital encoded
signal is detected.
ANALOG
Lights when an analog signal is detected.
DTS
Lights when a source with DTS encoded
audio signals is detected.
2 DTS
When the STANDARD mode of the receiver is
on, this lights to indicate decoding of a DTS
signal.
30
En
2 3 4
15 16 17
5 6 7 8 9
18 19
3 2 DIGITAL
When the STANDARD mode of the receiver is
on, this lights to indicate decoding of a Dolby
Digital signal.
4 2 PRO LOGIC II
When the (STANDARD) Pro Logic II mode of
the receiver is on, this lights to indicate Pro
Logic II decoding.
5 VIR.SB
Lights during Virtual surround back
processing.
6 ATT
Lights when INPUT ATT is used to attenuate
(reduce) the level of the analog input signal.
7 DIRECT
Lights when source direct playback is in use.
Direct playback bypasses the tone controls
and channel levels for the most accurate
reproduction of a source.
8 MIDNIGHT
Lights during Midnight listening.
9 SLEEP
Lights when the receiver is in sleep mode.
10 RF ATT
Lights when the RF attenuator is on (page 52).
10 11 12 13 14
RFATT EON
RDS
SP A B
20