Listening To Multi-Channel Playback - Pioneer VSX-D712 Operating Instructions Manual

05 Playing sources
• Press SIGNAL SELECT (front panel) to
select the input signal corresponding to
the source component.
Each press cycles through the options as
follows:
DIGITAL
The AUTO setting automatically switches to
DIGITAL if a digital source is detected, other-
wise the signal select will be ANALOG.
DVD 5.1ch (VSX-D712) and DVD 7.1ch (VSX-
D812) will only appear when DVD/LD is
selected.
When set to DIGITAL or AUTO, 2 DIGITAL
lights when a Dolby Digital signal is input,
and DTS lights when a DTS signal is input.
• This receiver can only play back Dolby
Digital, PCM (32kHz–96 kHz) and DTS
digital signal formats (however, only the
VSX-D812 can decode DTS 96kHz/24 bit
signal formats). With other digital signal
formats, set to ANALOG.
• You may get digital noise when a LD or CD
player compatible with DTS is playing an
analog signal. To prevent noise, make the
proper digital connections (page 16) and
set the signal input to DIGITAL.
• Some DVD players don't output DTS
signals. For more details, refer to the
instruction manual supplied with your
DVD player.
38
En
AUTO
DVD 5.1 ch/
DVD 7.1 ch
ANALOG
Listening to multi-channel
playback
RECEIVER
INPUT SELECT
MULTI CONTROL
DVD/LD TV / SAT
C D CD-R/TAPE
STANDARD
1 Switch on the playback component.
2 Turn on the power of the receiver.
3 Select the source you want to play-
back.
Use the MULTI CONTROL buttons (or INPUT
SELECT).
4 Press STANDARD.
If the source is Dolby Digital, DTS, or Dolby
Surround encoded, the proper decoding
format will automatically be selected and
shows in the display.
If you are listening to a two channel source,
each press changes the display as follows:
MOVIE
(2 Pro Logic II)
MUSIC
(Neo:6)
CINEMA
(Neo:6)
Refer to page 36 for more details about each
mode.
VCR/DVR TV CONT
TUNER
MUSIC
(2 Pro Logic II)
PROLOGIC