Selecting The Multi-Channel; Analog Inputs; Using The Sleep Timer - Pioneer VSX-D712 Operating Instructions Manual

Playing sources
4 Start playback of the component you
selected in step 1.

Selecting the multi-channel

analog inputs

If you have connected a decoder or a DVD
player with multi-channel analog outputs to
this receiver (page 18), you must select the
analog multi-channel inputs for surround
sound playback.
DVD/LD TV/SAT VCR/DVR VIDEO
CD-R/
CD TAPE/MD AUX
TUNER
STANDBY
STANDBY / ON PULL OPEN
PHONES
ADVANCED STEREO/ SIGNAL MIDNIGHT/
STANDARD SURROUND DIRECT SELECT LOUDNESS
PHONES SURR.
LISTENING MODE
INPUT ATT FL DIMMER
1 Press DVD/LD.
2 Press SIGNAL SELECT repeatedly to
select DVD 5.1ch/DVD 7.1ch.
To cancel playback from the multi-channel
inputs, use the SIGNAL SELECT button to
select a different input signal.
ADVANCED STEREO/
STATION TUNING
STANDARD SURROUND DIRECT
PHONES SURR.
LISTENING MODE
TUNER EDIT CLASS BAND MPX INPUT ATT FL DIMMER
MULTI JOG
QUICK
SB CH
SPEAKERS MODE TONE SETUP
MULTI JOG
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
• When playback from the multi-channel
inputs is selected, you can't use the
INPUT ATT, TONE, and MIDNIGHT/
LOUDNESS buttons, as well as the STAN-
DARD, ADVANCED SURROUND, and
STEREO/DIRECT sound modes.
• When playback from the multi-channel
inputs is selected, only the volume and
channel levels can be set.

Using the sleep timer

The sleep timer switches the receiver into
standby after a specified amount of time so
you can fall asleep without worrying about the
receiver being left on all night. Use the remote
control to set the sleep timer.
1 Press RECEIVER.
2 Press SLEEP repeatedly to set the sleep
time.
90 min
Off
• You can check the remaning sleep time at
any time by pressing SLEEP once.
Pressing repeatedly will cycle through the
sleep options again.
• You can also switch off the sleep timer
simply by switching off the receiver.
60 min
30 min
05
43
En