Pioneer VSX-D712 Operating Instructions Manual page 66

10 Additional information
Problem
Broadcast stations cannot be
selected automatically.
No sound from surround or
center speakers.
No sound from surround
back speakers.
No sound from subwoofer.
Noise during playback of a
cassette deck.
Sound is produced from
other components, but not
from LD or DVD player.
No sound is output or a noise
is output when software with
DTS is played back.
When a search is performed
by a DTS compatible CD
player during playback, noise
is output.
Can't operate the remote
control.
The display is dark or off.
66
En
Remedy
• Connect an outdoor antenna (refer to page 20).
• Refer to Speaker setting on page 45 to check the speaker settings.
• Refer to Manually calibrating your listening area (MCACC) on
page 51 to check the speaker levels.
• Connect the speakers properly (refer to page 21 or page 22).
• Refer to Surround back speaker setting on page 46 to check the sur-
round back speaker settings.
• Refer to Using the Surround Back Channel (SB CH) on page 40 to
make sure the SB CH MODE and the sound mode are set for sur-
round back sound.
• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it's turned up.
• Switch the Subwoofer setting on page 46 to YES or PLUS.
• Switch the LFE attenuator setting on page 47 to 0 dB or 10 dB.
• The Dolby Digital or DTS source you are listening to does not have
an LFE channel.
• Move the cassette deck further from your receiver, until the noise
disappears.
• Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG accord-
ing to the type of connections made. (refer to page 37).
• Set the digital input settings correctly (refer to page 50).
• Make digital connections (refer to page 16) and set the SIGNAL
SELECT to DIGITAL (refer to page 37).
• Refer to the instruction manual supplied with the DVD player.
• Set the digital volume level of the player to full, or to the neutral
position.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
• Replace the batteries (refer to page 6).
• Operate within 23 feet ( 7 m), 30° of the remote sensor on the front
panel (refer to page 7).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press FL DIMMER on the remote control repeatedly to return to
the default.