Setup (Windows Pc); Device Recognition (Windows Pc); Software Installation (Windows Pc) - SoftBank 004Z User Manual

Setup (Windows PC)

Device Recognition (Windows PC)

2
With USIM Card installed, insert modem USB plug into PC
USB port. PC should automatically recognize modem
within approximately 45 seconds.
System message appears upon modem recognition. See
"Software Installation (Windows PC)" to install SoftBank
004Z Utility.
2-2
• Modem may fail if PC enters sleep mode, etc. with it connected.
Remove modem before leaving a PC unattended, etc. Modem
may malfunction if connected before PC starts/restarts. Remove
modem before starting or restarting PC.

Software Installation (Windows PC)

Use this modem to access Network or adjust settings.
All screenshots and procedures based on Windows 7.
Installing SoftBank 004Z Utility
• Do not remove modem during installation. May cause
installation failure, system malfunction or other system errors.
• Login using administrator privilege.
Power on PC and initiate Windows
Insert modem into PC
Utility installer and device driver are stored on modem.
Modem installs as USB mass-storage device at first use.
(Device recognition takes approximately 45 seconds.)
Utility installer starts, device driver and utility software
install automatically
• If an older version of SoftBank 004Z Utility is already installed a
message appears. Remove old version before installation (See
"Uninstalling SoftBank 004Z Utility" on P.2-8.).