ViewSat 9000HD User Manual page 6

3.2. REAR PANEL
1) DISH IN: This port is to connect the coaxial cable from LNB of your Dish. The IF input
is provided through this port and the input frequency range is 950~2150MHz.
voltage switching 13V and 18V is passed through this port.
2) LOOP OUT: To enable the connection of an analog receiver, the receiver is provided
with this port. Connect this port to LNB IN port of the other receiver via RF Cable.
3) ANT IN: To connect to TV ANT input. (Option).
4) LOOP OUT: To connect to the other satellite receiver. (Option).
5) SERIAL PORT: Connect your receiver to a computer with a serial cable. This port
can be used for upgrading software.
6) USB HOST PORT: This is used to connect your USB Device to your receiver.
(Either front side USB port or rear side must be selected in the menu.)
7) HDMI: To connect HDMI input of TV or PC monitor.
8) S/PDIF DIGITAL OUTPUT: This port is for the connection to the external Hi-Fi
system which has an optical S/PDIF input interface (Option).
9) S-VIDEO: Connect to your TV with a S-Video cable.
10) VIDEO, AUDIO R/L, COMPONENT(Y, Pb, Pr): These RCA connectors are used to
connect any external video and audio.
11) POWER INPUT: This is the AC main power cord. The input AC volts range is 95V to
240V, 50Hz/60Hz supply.
12) POWER SWITCH: This is a switch to turn on and off the AC main power.
13) Reserved for UHF Remote Antenna Module
9
3.3. REMOTE CONTROL UNIT
Also, the
REMOTE CONTROL UNIT REMOTE CONTROL UNIT REMOTE CONTROL UNIT REMOTE CONTROL UNIT
10