Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System; Cleaning The Parksense System - Dodge Charger SRT 2018 Owner's Manual

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with the ParkSense
switch.
When the ParkSense switch is pushed to disable
the system, the instrument cluster will display
the "ParkSense Off" message for approximately
five seconds. Refer to "Instrument Cluster Dis-
play" in "Getting To Know Your Instrument Panel" for
further information. When the gear selector is moved to
REVERSE and the system is disabled, the instrument
cluster display will display the "ParkSense Off" message
for as long as the vehicle is in REVERSE.
The ParkSense switch LED will be on when ParkSense is
disabled or defective. The ParkSense switch LED will be off
when the system is enabled. If the ParkSense switch is
pushed and the system is disabled or requires service, the
ParkSense switch LED will blink momentarily and then the
LED will be on.

Service The ParkSense Rear Park Assist System

During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the instru-
ment cluster display will actuate a single chime, once per
ignition cycle, and it will display the "PARKSENSE UN-
AVAILABLE WIPE REAR SENSORS" or the "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message. Refer to
"Instrument Cluster Display". When the gear selector is
moved to REVERSE and the system has detected a faulted
condition, the instrument cluster display will show the
PARKSENSE UNAVAILABLE WIPE REAR SENSORS or
PARKSENSE UNAVAILABLE SERVICE REQUIRED mes-
sage for as long as the vehicle is in REVERSE. Under this
condition, ParkSense will not operate.
If "PARKSENSE UNAVAILABLE WIPE REAR SENSORS"
appears in the instrument cluster display, make sure the
outer surface and the underside of the rear fascia/bumper
is clean and clear of snow, ice, mud, dirt or other obstruc-
tion and then cycle the ignition. If the message continues to
appear, see an authorized dealer.
If "PARKSENSE UNAVAILABLE SERVICE REQUIRED"
appears in the instrument cluster display, see an autho-
rized dealer.

Cleaning The ParkSense System

Clean the Rear Park Assist sensors with water, car wash
soap and a soft cloth. Do not use rough or hard cloths. In
washing stations, clean sensors quickly keeping the vapor
STARTING AND OPERATING 259
6