Invalid Configuration States Of The Et 200Mp On Profinet Io; Stop Of The Io Controller And Recovery Of The Io Device - Siemens SIMATIC ET 200MP Manual

4.3.3

Invalid configuration states of the ET 200MP on PROFINET IO

Invalid configuration states
The following invalid configuration states of the ET 200MP lead to a short failure of the
ET 200MP IO device or prevent the exchange of user data with the I/O modules.
● Number of modules exceeds maximum configuration
● Faulty backplane bus (e.g., additional IM present).
Additional information
You can find additional information on maximum configuration and on power budget in the
s7-1500, ET 200MP automation system
(https://support.industry.siemens.com/cs/ww/en/view/59191792) system manual.
See also:
Status and error displays (Page 17)
4.3.4

STOP of the IO controller and recovery of the IO device

STOP of the SIMATIC IO controller
Diagnostic data received from the IO device while the IO controller is in STOP state does not
initiate a call of the corresponding OBs when the IO controller goes into RUN. You have to
read the data record E00C
diagnostic data for the slots assigned to an IO controller in an IO device.
Recovery of the SIMATIC IO device
If you want to read the diagnostic data in the STOP state of the IO controller, you have to
read the E00C
diagnostic data for the slots assigned to an IO controller in an IO device.
Interface module IM 155-5 PN BA (6ES7155-5AA00-0AA0)
Manual, 02/2017, A5E38017683-AA
using the "RDREC" in the startup OB. This record contains all
H
data record using the "RDREC" instruction. This record contains all
H
Interrupts and diagnostic, error, and system alarms
4.3 Alarms
23