Don't; Lubrication - Emerson EIM 2000 Series Installation And Maintenance Manual

Section 1: Storage Instructions
August 2017
1.3 Do
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1.4

Don't

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
1.5

Lubrication

EIM Actuators are factory filled with a high quality lubricant carefully selected to insure
actuator performance under specified operating conditions. Refer to EIM JOB SPEC
SHEET to identify the lubricant provided. Normal operation of actuator will not require
replacement of lubricant.
2
Do follow proper storage procedures. Improper storage will void warranty.
DANGER: Do check for proper motor rotation. If valve goes wrong direction when
button is pushed, you have no torque or limit protection.
Either incoming power or motor wiring must be reversed.
Do read and follow procedures before attempting to energize actuator.
Do cut off electric power before opening switch compartment.
Do install pressure relief vent in highest point of gearbox.
Do use stem covers of sufficient length to protect valve stem.
Do clean Electrical Enclosure flange thoroughly & lightly grease before closing.
Do secure all Electrical bolts.
Do follow an annual maintenance procedure.
Do use caution when working on, with, or around valves and actuators. You are
dealing with high pressures, forces, voltages and flammable or toxic media.
Start-up without reading this manual.
Don't stack actuators.
Don't store actuator on the ground unprotected.
Don't lift the unit by clutch lever or handwheel.
Don't lift a valve assembly by electric actuator.
Don't operate electrically without first checking for proper phase rotation, valve
position, torque and limit switch adjustments.
Don't plug the motor by starting and stopping repeatedly to move a valve that is
too stiff. Check for cause.
Don't jumper torque switches except as recommended by Wiring Diagram or
Valve Manufacturer.
Don't use oversize thermal motor overloads to eliminate a tripping problem.
Find the cause and correct.
Don't use a cheater to try to force the handwheel. You can damage gearing and
shafting. Find the cause and correct.
Don't torque seat valve, sluice gate or damper unless the valve manufacturer
recommends.
Installation and Maintenance Manual
E2K-401-0817 Rev. 1
Storage Instructions