Getting Started; Connecting The Base - Motorola L702BT User Manual

Doc Title : Product Data – User's Guide
Model : Motorola L70×BT
1

GETTING STARTED

WARNING
Do not place your phone in the bathroom or other humid areas.
Location
When choosing a location for your new phone, here are some important guidelines you should consider:
․
Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, heating appliances and
direct sunlight.
․
Avoid areas of excessive dust, moisture, and low temperature.
․
Avoid other cordless telephones or personal computers.
․
Never install telephone wiring during a lightning storm.
․
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
․
Never touch non-insulated telephone wires or terminals unless the telephone line has been disconnected at the
network interface.
․
Use caution when installing or modifying telephone lines.
HANDSET RANGE
Optimal range is reached when there are no other electrical appliances working within the range area. Any
obstruction between the base and handset will also reduce the range significantly.
SIGNAL STRENGTH
When out of range of the base, the screen shows OUT OF RANGE. If you are on a call, the line will disconnect.
Move back within in range of the base. The handset will automatically re-connect to the base.
Setting up
IMPORTANT
The base must be plugged into an electrical outlet at all times. Do not connect the telephone line cord into a power
outlet until the handset is fully charged. Only use adapter and telephone line cord supplied with the product.
WHICH POWER ADAPTER
The power adapter with the smaller pin is for the base unit and the power adapter with the larger pin is for the
charger unit (only for multi-handset packs).

1.1 Connecting the base

1. Plug the power adapter with smaller round pin plug and the telephone line cord into the base. The power
adapter with bigger round pin plug is for the charger (only in multi-handset packs).
2. Plug the other end of the power adapter into a power outlet and the telephone line cord into a telephone wall
jack.
3. Use only the provided power adapter.
This document contains confidential and proprietary information of VTech Telecommunications Ltd
Revision :
Page(s) :
R.00
7 of 27