Lfe Attenuator Setup; Sr+ Setup For Pioneer Plasma Displays - Pioneer 915 Operating Instructions Manual

12 Other Settings
1 Select DUAL MONO from the OTHER
setup menu.
2 Use (cursor up/down) to choose the
setting that you want.
• CH1 – Only channel 1 is played
• CH2 – Only channel 2 is played
• CH1 CH2 – Both channels are played
through the front speakers
3 When you're finished, press RETURN .

LFE Attenuator Setup

• Default setting: ATT 0 dB
Some Dolby Digital and DTS audio sources
include ultra-low bass tones. Set the LFE
attenuator as necessary to prevent the ultra-
low bass tones from distorting the sound from
the speakers.
1 Select LFE ATT from the OTHER setup
menu.
2 Use (cursor up/down) to choose the
setting that you want.
• LFEAT 0 – No limiting (recommended
setting)
• LFEAT 10 – 10dB of limiting
• LFEAT ** – No sound from LFE channel
3 When you're finished, press RETURN .
SR+ Setup for Pioneer plasma
displays
Make the following settings if you have
connected a Pioneer plasma display to this
receiver using an SR+ cable. Note that the
number of function settings available will
depend on the plasma display you've
connected.
See also Using this receiver with a Pioneer
plasma display on page 64 and Using the SR+
mode with a Pioneer plasma display on page 65.
1 Select 'SR+' from the OTHER setup menu.
68
En
2 Use (cursor up/down) and ENTER to
select the 'VOL C.' setting you want.
• VOL C. OFF – The receiver does not control
the volume of the plasma display
• VOL C. ON – When the receiver is switched
to one of the inputs that use the plasma
display (DVD/LD, or another one of
functions below), the volume on the
plasma display is muted so only sound
from the receiver is heard.
3 Assign any input source connected to the
plasma display to the corresponding input
number.
Use (cursor left/right) to select the
source (DVD, TV, DVR or VDEO), then
(cursor up/down) to select the input number.
This matches the receiver's input source with a
numbered video input on the plasma display.
For example, assign DVD:3 if you have
connected the your DVD video output to video
input 3 on the plasma display.
4 When you're finished, press RETURN .