Pioneer 915 Operating Instructions Manual page 71

Additional information
Problem
No sound is output or a noise
is output when software with
DTS is played back.
When a search is performed
by a DTS compatible CD
player during playback, noise
is output.
Everything seems to be set up
correctly, but the playback
sound is odd.
There seems to be a time lag
between the speakers and the
output of the subwoofer.
After using the Auto MCACC
Setup, the speaker size
setting (LARGE or SMALL) is
incorrect.
Can't operate the remote
control.
The SR cable is connected,
but the connected
components can't be
operated with the remote.
The display is dark or off.
Remedy
• Set the digital volume level of the player to full, or to the neutral
position.
• Make sure the player's settings are correct and/or the DTS signal out
is on. Refer to the instruction manual supplied with the DVD player.
• Set the input signal type to DIGITAL (see Choosing the input signal
on page 38)
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Check that the positive/negative speaker terminals on the receiver are
matched with the corresponding terminals on the speakers (see
Connecting the speakers on page 23).
• See Automatically setting up for surround sound (MCACC) on page 12
to set up your system again using MCACC (this will automatically
compensate for a delay in the subwoofer output).
• Low-frequency noise could have been caused by an air conditioner or
motor. Switch off all appliances in the room and rerun the Auto
MCACC Setup.
• Replace the batteries (refer to page 7).
• Operate within 23 ft. (7 m), 30° of the remote sensor on the front
panel (refer to page 33).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Unplug anything connected to the CONTROL IN jack and use remote
normally (see Operating other Pioneer components on page 26).
• Reinsert the SR cable, making sure it's connected to the right jack
(see Operating other Pioneer components on page 26).
• Make sure an analog connection has been made between the units.
• This feature only works with Pioneer products.
• Press FL DIMMER on the remote control repeatedly to return to the
default.
13
71
En