Erasing One Of The Remote Control Button; Settings; Erasing All Of The Remote Control Presets; Direct Function - Pioneer 915 Operating Instructions Manual

Controlling the rest of your system
Certain buttons represent operations that
cannot be learned from other remote controls.
The buttons available are shown below:
INPUT
RECEIVER SOURCE
SELECT
DVD/LD TV/SAT DVR/VCR TV CONT
MULTI CONTROL
CD CD-R/TAPE TUNER RECEIVER
FL DIMMER SR
DISC
+10
ENTER
D.ACCESS CLASS
TOP MENU MENU
TUNE
ST ST
DTV MENU
ENTER
BAND
T.EDIT
TUNE
SYSTEM
SETUP
GUIDE RETURN
6 To program additional signals for the
current component repeat steps 4 and 5.
To program signals for another component,
exit and repeat steps 1 through 5.
7 Press the RECEIVER button to exit and
store the operation(s).
Erasing one of the remote
control button settings
VSX-915 model only
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1 While pressing the RECEIVER button,
press and hold the 1 button.
The remote LCD display shows SETUP.
2 Press the MULTI CONTROL button
corresponding to the button setting to be
erased.
The LCD on the remote displays the
component.
GUIDE RETURN
TV CONTROL
INPUT
VOL
TV VOL TV CH
SELECT
DTV ON/OFF REC DTV INFO MUTE
TUNER
REC STOP
DISPLAY
MPX CH RETURN
HDD DVD
AUDIO SUBTITLE
CH CH
RECEIVER CONTROL
THX STANDARD ADV.SURR STEREO
ACOUSTIC SIGNAL MIDNIGHT/
EQ SELECT LOUDNESS
AUTO SURR
EFFECT
SHIFT SLEEP DIALOG E
/CH SEL
RECEIVER
3 Use (cursor left/right) to select
ERASE then press ENTER .
The LCD display flashes PRES KEY.
4 Press and hold the button to be erased for
two seconds.
The LCD display shows OK or NO CODE to
confirm the button has been erased.
5 Repeat step 4 to erase other buttons.
6 Press the RECEIVER button when you're
done.
Erasing all of the remote control
presets
This will erase all preset remote control preset
codes and (VSX-915 model only) programmed
buttons.
1 While pressing the RECEIVER button,
press and hold the 1 button.
The remote LCD display shows SETUP.
2 Press the DVD/LD MULTI CONTROL
button.
3 Use (cursor left/right) to select
RESET then press and hold ENTER for about
two seconds .
The LCD shows OK to confirm the remote
presets have been erased.

Direct function

• Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
10
57
En