Saving Station Presets; Naming Station Presets - Pioneer 915 Operating Instructions Manual

08 Using the tuner

Saving station presets

If you often listen to a particular radio station,
it's convenient to have the receiver store the
frequency for easy recall whenever you want to
listen to that station. This saves the effort of
manually tuning in each time. This unit can
memorize up to 30 stations, stored in three
banks, or classes, (A, B and C) of 10 stations
each. When saving an FM frequency, the MPX
setting (see previous page) is also stored.
D CD-R/TAPE/MD TUNER
VIDEO INPUT
S-VIDEO VIDEO
L AUDIO R
INPUT
FL DIMMER ATT
TUNING
BAND /STATION
INPUT
RECEIVER
SELECT
DVD/LD TV/SAT DVR/VCR
MULTI CONTROL
CD CD-R/TAPE TUNER
Note
1 If the receiver is left disconnected from the AC power outlet for over a month, the station memories will be lost and will have
to be reprogrammed.
52
En
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
MULTI JOG
ENTER
AUX
MASTER
VOLUME
MCACC
DIGITAL IN SETUP MIC
DOWN UP
EXTENDED
ACOUSTIC
SPEAKERS MODE EQ
TUNER QUICK SYSTEM
EDIT TONE SETUP SETUP RETURN
MULTI JOG
ENTER
D.ACCESS
TOP MENU
SOURCE
TUNE
ST ST
DTV MENU
ENTER
T.EDIT
TUNE
SYSTEM
SETUP
RETURN
GUIDE
TV CONTROL
INPUT
TV VOL TV CH VOL
SELECT
TV CONT
DTV ON/OFF REC DTV INFO MUTE
TUNER
RECEIVER REC STOP
DISPLAY
MPX CH RETURN
HDD DVD
AUDIO SUBTITLE
CH CH
1 Tune to a station you want to memorize.
See Listening to the radio on the previous page
for more on this.
2 Press T.EDIT (TUNER EDIT).
The display shows ST. MEMORY, then a
blinking memory class.
3 Press CLASS to select one of the three
classes then press ST +/– to select the station
preset you want.
You can also use the number buttons or the
1
MULTI JOG dial (front panel) to select a station
preset.
4 Press ENTER.
After pressing ENTER, the preset class and
number stop blinking and the receiver stores
the station.

Naming station presets

For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See Listening to station presets below for how
to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows ST. NAME, then a blinking
cursor at the first character position.
3 Input the name you want.
CLASS
MENU
Choose a name up to four characters long.
• Use the MULTI JOG dial (front panel) or the
BAND
ST +/– buttons (remote) to select
characters.
• Press ENTER to confirm a character. If no
character is input, a space is input.
• The name is stored when ENTER is pressed
after choosing the fourth character.