Bluetooth Remote - Lupine BLIKA R Owner's Manual

Bluetooth Remote

The Bluetooth Remote comes together with the Peppi V5 barmount (helmet & bikelights) or a bracelet
(Headlamps). On the bike, the best way to mount the remote is directly next to your grips so you have
full control and don't need to take off your hands while riding. The bracelet can be attached to a lot of
other things like ski poles, too.
Connecting the transmitter to the light:
By default, your lamp has already been connected to the transmitter.
For establishing a connection, the receiving mode in the lamp has to be activated.
Keep the lamp's button depressed the switch turns up
The receiving mode is active for 30 seconds. During this time, press the remote control's green button
until the remote does light up green, too.

Several lamps on one transmitter:
It is possible to connect up to fi ve lampheads to a single remote switch.
Several transmitters on one lamp / Unbinding:
Up to 4 transmitters may be connected to one lamp. The transmitters are stored in the lamp in turn.
If you like to remove a transmitter from the light, set the light into receiving mode and keep the green
switch of the transmitter pressed until it turns red. (Aprox. 20 sec.)
28 Blika R
green (after 15 sec) and let the button go.
release the button.
Blue button: Turning the lamp on and off . Depending on the control concept : Same
functions as the top button of the lamphead or increase the output.
Green button: Control the Special-LEDs, (same function as the low button of the lamp-
head) or reduce the output.
Switching between operating concepts 1 and 2:
Press and hold the green pushbutton of the remote control until the blue and green
LEDs fl ash alternately, then let the button go.
Enable/Disable the remotes permanent LED light:
To enable or disable, hold down the blue button the remote control:
The green LEDs turn on (keep pressing the button), as soon the green LEDs turn off
and the blue LEDs turn on let the button go

Low battery warning from lamphead:
The remote mirrors the lamphead's low battery warning. A fully charged or partly discharged
battery will be shown by a red LED light. Details see page 36.
Low button cell:
With decreasing voltage, the remotes LEDs will also become weaker, to the point the remote
does not work anymore. Also cold temperature does reduce the battery voltage. If the button cell
is empty, it's represented by a red light.
Transmitter battery change:
of the transmitter using a T5 torx screw driver.
Insert the new CR 2032 button cell as shown and close
the transmitter again.
Tighten the screws until the blue sealing is visibly squeezed.
T5 torx screw driver: (Art.No. 137)
Blika R 29