Basic Operations
This section provides an overview of the watch
and its operations.
Note
The illustrations included in this
●
operation guide have been created
to facilitate explanation. An
illustration may differ somewhat
from the item it represents.
Watch Face Items
①
②
③
④
⑦
⑧
⑨
A Day of week
In the Timekeeping Mode, the day of the week
hand indicates the day of the week in the
current Home City.
B Airplane Mode mark
While the watch is in the Airplane Mode, the
day of the week hand points to h.
C Signal receive status, location information
availability
When checking the last receive result :
The day of the week hand indicates the
information that was received or acquired for
the last time adjustment.
"P": GPS signal time or phone time information
and location information
"N": GPS signal time information or time
calibration signal
When setting the Home City or World Time
City :
The day of the week hand indicates whether
or not location information is available for the
Home City or World Time City.
"P": Location information available
"N": Location information not available
Operation Guide 5531
D Battery level
The current charge level is temporarily
indicated by the mode hand immediately after
you enter the Timekeeping Mode.
E Latitude
When the watch acquires location
information, or connects with a phone and
adjusts its time setting, the day of the week
hand will indicate the rough latitude of the city
for which information was acquired.
F Summer time setting
The day of the week hand points to the
summer time setting for the current Home City.
G C mark
The second hand points to this mark while
there is a connection between the watch and
a phone.
⑤
H RC mark
⑥
The second hand points to this mark while
calibration signal reception is in progress.
⑩
I Alarm settings
⑪
In the Alarm Mode, the second hand indicates
if the alarm is enabled or disabled.
"ON": Alarm enabled
"OFF": Alarm disabled
⑫
J T (Time) mark
The second hand points to this mark while
GPS (time information) signal reception is in
progress.
K T+P mark
The second hand points to this mark while
GPS (location information) signal reception is
in progress.
L Last signal receive result
The second hand points to the letter that
indicates the result of the last time adjustment
operation by receipt of a signal or connection
with a phone.
"Y(YES)": Last time adjustment operation
successful.
"N(NO)": Last time adjustment operation
failed.
Navigating Between Modes
Your watch has the modes shown below.
Timekeeping Mode
C
Alarm Mode
Stopwatch Mode
While in the Timer Mode
C
C
C
(Approximately
2.5 seconds)
Bluetooth connection
Use the (C) button to navigate between
modes.
Hold down (C) for at least one second to return
to the Timekeeping Mode.
To connect with a phone, hold down (C) for
about 2.5 seconds.
C
C
2