Moving To Another Time Zone - Casio QW 5531 Operation Manual

4.
If the small hour hand and small minute
hand are not at 12 o'clock, rotate the
crown to align them correctly.
5.
Press (C).
Confirm that "UTC" is centered in the
indicator window.
Indicator window
6.
If "UTC" is not positioned in the center of
the indicator window, rotate the crown
until it is.
7.
Press (C).
Confirm that the day of the week hand is
stopped at 12 o'clock, and check if the day
is indicated properly.
Day of the week hand
Day (Operation start day)
8.
If the day of the week hand and or the day
indicator is out of alignment, rotate the
crown to move the day of the week hand
to 12 o'clock and the day to the center of
the indicator window.
The movement range of the day of the
●
week hand and day indicator is limited
when you rotate the crown. The
maximum left-right movement of the
day of the week hand is 180 degrees in
either direction. The day indicator
moves only slightly.
After the day of the week hand and day
●
indicator are in the positions you want,
advance to step 11 of this procedure. If
you are unable to make the adjustments
you want, go to step 9.
Operation Guide 5531
9.
Press (C).
Confirm that the day indicator shows 1.
Changing the date setting will cause the
●
day of the week hand to rotate
repeatedly. In some cases, the day of
the week hand may continue to rotate
for about 5 minutes.
Hand and Day Indicator Movement
l
10.
If 1 is not shown for the day, rotate the
crown until 1 is shown for the day.
The day of the week hand moves in
●
conjunction with crown rotation. Move
the day of the week hand to 12 o'clock.
11.
Push the crown back in.
Note
Leaving the crown pulled out for
●
more than approximately 30 minutes
without performing any operation
will automatically cause the
adjustment operation to become
disabled. If this happens, push the
crown back in to its normal position
and then pull it out again to restart
the procedure from the beginning.
Pushing the crown in to its normal
position part way through the
alignment procedure will cause the
hands to return to their normal
position. Any alignment you
performed up to that point will be
applied.
Moving to Another Time
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
●
Configure the World Time to the current time
at your destination.
Day
l
●
Enter the watch's Airplane Mode when
instructed to do so by airline personnel.
l
●
1.
2.
Zone
Before Boarding
Current time
Destination time
Specifying a World Time City
Prior to Takeoff
Airplane mark
Using the Watch in a Medical Facility or
Aircraft
After Arriving
Swap the origin time zone time with the
destination time zone time.
Before swapping After swapping
Destination time Destination time
Swapping Your Home City Time and
l
World Time
Exit the Airplane Mode.
Using the Watch in a Medical Facility or
l
Aircraft
19