Linksys WAP300N Manual page 8

•
If the device is connected to a network with a DHCP server (usually the network router), then the
device will obtain its IP address from the DHCP server. In this case, find the device's IP address in
the DHCP client table of your router (refer to the documentation for your router.)
•
If there is no DHCP server (for example, if WAP300N is not wirelessly connected to any other device
and it is connected directly to a computer with an Ethernet cable), then the device will use its
default IP address, 10.100.1.1, until the device detects a DHCP server which will assign a dynamic IP
address to the device.
•
If you have set a static IP address on this device through the browser-based utility, then enter the
static IP address instead. If you have set a static IP address on this device but have forgotten the IP
address, you can reset the device; press the Reset button on the device for approximately five
seconds using a straightened paper clip. This will reset the device back to the factory default settings.
Setup > Basic Setup
The first screen that appears is the Basic Setup screen. Use this screen to change the browser-based
utility's language, or to change the device's wired Ethernet network settings.
Language