Advertisement
LEDs, Ports and Buttons
LEDs
Wireless
In WMC and WRE mode, the Wireless LED lights (solid) up when there is a wireless connection to the
wireless router (or access point).
In WB mode, the Wireless LED lights (solid) up when there is a wireless connection to another WAP300N.
In all modes, the Wireless LED flashes when the device is actively sending or receiving data over its
wireless interface.
TM
Wi-Fi Protected Setup
The LED flashes slowly for two minutes during Wi-Fi Protected Setup. It lights up when wireless security
is enabled. If there is an error during the Wi-Fi Protected Setup process, the LED would flashes quickly
for two minutes. Make sure the wireless client device or wireless router, that you want to connect to
WAP300N, supports Wi-Fi Protected Setup. Wait until the LED is off, and then try again.
Ethernet
The Ethernet LED lights up when there is a wired connection. The LED flashes when the Access Point is
actively sending or receiving data over the Ethernet port.
Power
The Power LED lights up when the device is powered on.
Advertisement
