JVC RX-8040B Service Manual page 11

3.12 Removing the voltage selector board
(See Fig.14 and 15)
• Prior to performing the following procedures, remove the top
cover.
(1) From the back side of the main body, remove the two
screws S attaching the voltage board. (See Fig.14)
(2) Remove the solders from the soldered sections b on the
power transformer board 2 and remove the wires of the
voltage selector board. (See Fig.15)
(3) Take out the voltage selector board.
Rear panel
Fig.14
Soldered sections b
Fig.15
S
Power
transformer
board 2
Tie bands
Voltage
selector
board
(No.MB303)1-11