3 Quick Setup
These few hints will help you setting up your new PA system in an instant:
Apply mains power
Ensure that the power switch rests in its "OFF"-position ("0" is pressed down on the rocker)
•
Apply mains power via the IEC connector (10)
•
Caution: observe the appropriate voltage range of 85 – 265V / 50-60 Hz!
Power up the unit by turning on the mains switch (9). The operation status – LED (26) should
•
turn green.
USB player
To use the USB player insert an USB stick containing the media to be played.
USB Player operation:
starting the playback: Press „Play / Pause" (16).
•
pausing the playback : again, press „Play / Pause" (16).
•
(12) sets the playback volume.
•
Skip song:
press → next (17) or ← previous (15).
•
Change folder: long press on → next (17) or ← previous (15).
•
If playback is impossible the USB-LED will light red.
Either no valid media could be found or the USB stick could not be detected. See Chapter 5.1.3
Supported audio file formats for further information.
Connect audio sources
See Illustration 2.2. for connection possibilities.
•
To avoid pop noise when connecting the sources low down the Master (25) or Chan-
nel-Volume (18), (21) in advance.
Set input sensitivity / mode to meet the requirements of the connected sources. Pressing
•
the input mode buttons (2), (5) toggles the input modes.
The labels near the input mode buttons show the association of the selected mode with the
displayed color (see Illustration 2.1). All modes and their fitting application are summarized by
the table below:
7