Component Out (Not Applicable To The European Model) - Pioneer S-DV313 Operating Instructions Manual

Initial Settings menu
• Default setting: Video
• If you make a setting here that is incom-
patible with your TV, the TV may not
display any picture at all. If this happens
switch everything off and reconnect to the
TV using the supplied audio/video cable.
• SCART cables come in various configura-
tions. Make sure you use the correct one
for your TV/monitor. See page 72 for the
SCART pin assignment diagram.
Initial Settings
Video Output
TV Screen
Language
AV Connector Out
Display
Options
• Video – Standard video, compatible with
all TVs.
• S-Video – Higher quality, but check your
TV for compatibility.
• RGB – Best quality, but check your TV for
compatibility.
Component Out
Not Applicable to the European model
You only need to make this setting if you
connected this system to your TV using the
component video outputs.
• Default setting: Interlace
Initial Settings
Digital Audio Out
TV Screen
Video Output
Auto Progressive
Language
Component Out
Display
S-Video Out
Options
If you have a progressive-scan compatible TV,
set this to Progressive for flicker-free video
output. If your TV is not compatible with
progressive-scan video, set to Interlace.
Check the operating instructions that came
with your TV if you're unsure about its
compatibility.
When setting to Progressive, you have to
press ENTER once more to confirm (or
RETURN to cancel). See also below for
important information on progressive scan
video.
About progressive scan video
Compared to interlace video, progressive
scan video effectively doubles the scanning
Video
rate of the picture, resulting in a very stable,
S-Video
flicker-free image. Progressive scan video is
RGB
available only from the component video
output.
• When TV format is set to AUTO or NTSC
• If you connect a TV that is not compatible
Interlace
Progressive
only: When Component Out (above) is set
to Progressive, there is no video output
from the VIDEO and S-VIDEO jacks. If you
want to display video on more than one
monitor simultaneously, make sure that it
is set to Interlace. See also Setting the TV
format on page 73.
with a progressive scan signal and switch
the system to progressive, you will not be
able to see any picture at all. In this case,
press STANDBY/ON to put the system
in standby, then press and hold the front
panel (stop) button for about 8 seconds
until the display shows Mem.Clr.?. Press
the front panel VOLUME – (DOWN) or +
(UP) button so that the display shows
Interlace?. Press the front panel
button to set to interlace and switch the
system back on.
11
61
En