Test The Hyperterminal Setup - Enfora Spider AT User Manual

Spider® AT

TEST THE HYPERTERMINAL SETUP

1. Make sure the cursor is in the main window.
2. Type "
3. The modem should respond back with "0" or "OK" in the Main Window
4. If this happens, the COM port is configured correctly. If not, go back and
check your settings.
5. At this point you are ready to start configuring your device with AT
commands. Section 3.2 of this guide provides details about configuring your
device.
User's Guide
Figure 39 - HyperTerminal Program Window
" and press Enter
AT
P a g e 52 Revision: Draft