Maintenance And Upgrades; Replace The Ssd; Chapter - Cisco ASA 5508-X Hardware Installation Manual

Maintenance and Upgrades

This chapter contains procedure for maintaining and upgrading the ASA, and contains the following sections:
•

Replace the SSD

As mentioned in
SSD should it fail; you do not need to power off the ASA to do so.
Follow these steps to replace a failed SSD in an ASA:
Step 1 Loosen the thumb screws on both sides of the SSD bay and pull the existing SSD out of the bay.
Step 2
Insert the new SSD into the bay and push it in until it is seated.
Step 3 Tighten the thumb screws on both sides of the SSD bay.
Step 4 Check the SSD LED to make sure the SSD is seated properly and functioning. See
of the SSD LED.
Online Only
Replace the SSD , page 27
Solid State Drive, on page
C H A P T E R
7, the ASA ships with an SSD installed. You can replace this
Cisco ASA 5508-X and ASA 5516-X Hardware Installation Guide
4
LEDs, on page 4 for a description
27