Leds - Cisco ASA 5508-X Hardware Installation Manual

LEDs

5
7
9
LEDs
The LEDs are located just off center on the front panel, and just to the left of the network ports on the rear
panel, with the SSD LED to the right of the Reset port.
LED
Power
Cisco ASA 5508-X and ASA 5516-X Hardware Installation Guide
4
Management port
A Gigabit Ethernet interface
restricted to network
management access only.
Connect with an RJ-45 cable.
USB port
A standard USB Type A port
is provided, allowing
attachment of an external
device such as mass storage.
See Internal and External
Flash Storage, on page 6 for
additional information.
SSD LED
Status light for installed
solid-state drive (SSD). See
LEDs, on page 4 and Solid
State Drive, on page 7 for
more information.
Description
Power supply status:
• Unlit – Power supply off.
• Solid green – Power supply on.
See Power Supply Modules, on page 7
6 Console ports
Two serial ports, a mini USB Type B, and a
standard RJ-45 (8P8C), are provided for
management access via an external system. See
Console Ports, on page 6
information.
8 Reset button
A small recessed button that if pressed for longer
than three seconds resets the ASA to its default
"as-shipped" state following the next reboot.
Configuration variables are reset to factory default.
However, the flash is not erased, and no files are
removed.
Note You can use the service sw-reset-button
to disable the reset button. The default is
enabled.
10 SSD bay
Covered slot in which the SSD is installed. You
can replace this drive if it fails. See
SSD , on page 27
for additional power information.
Overview
for additional
Replace the
for more information.
Online Only