•
Thread the rope through the rotor
and secure it with a simple
overhand knot.
7
6
5
•
Coat rope rotor bearing bore with
non-resinous oil.
•
Slide rotor onto starter post -
turn it back and forth so that anchor
loop of rewind spring engages.
•
Refit the pawls in the rotor.
•
Fit the washer on the starter
post.
•
Use screwdriver or suitable pliers to
install spring clip on starter post
and over the pawl pegs -
the spring clip must point in clock-
wise direction - see illustration.
5
7HQVLRQLQJ UHZLQG VSULQJ
•
Make a loop in the starter rope and
use it to turn the rope rotor six full
revolutions in the direction of the
arrow.
•
Hold the rotor steady - straighten
the twisted rope.
•
Release the rotor.
•
Let go of rope slowly so that it
winds onto the rotor.
•
The starter grip must sit firmly in the
rope guide bush. If the grip droops
to one side: Increase spring tension
by one additional turn.
46