Basic Connections; Connecting The Power Cord - Pioneer PDP-436RXE Operating Instructions Manual

Preparation
Using a wall for stabilization
1. Attach falling prevention bolts (hooks) to
the Plasma Display.
2. Use strong cords or chains to stabilize it
appropriately and firmly to a wall, pillar, or
other sturdy element.
• Perform this work in the same way on the left and right sides.
NOTE
Use hooks, ropes, chains, and fittings that are available on the
market.
Recommended hook: Nominal diameter 8 mm Length 12 to 15
mm

Basic connections

Connecting the power cord

Plasma Display (rear view)
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core
to the connector end of the power cord as shown. Use
the supplied cable tie to prevent the ferrite core from
slipping on the cable.
To power
outlet
AC power cord
As close as possible
NOTE
• Disconnect the power cord from the power outlet when the
Plasma Display system is not going to be used for a long
period of time.
05
Europe, except
UK and Eire
UK and
Eire
Ferrite core
Cable tie
To AC IN
15
En