Power Control; Energy Save; No Signal Off; No Operation Off - Pioneer PDP-436RXE Operating Instructions Manual

Basic Adjustment Settings
08

Power Control

Power Control provides convenient functions for power saving.

Energy Save

You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Energy Save" ( /
4
Select "Save1", "Save2", or "Picture Off" ( /
ENTER).
Item
Standard
Save1
Save2
Picture Off
5
Press HOME MENU to exit the menu.
NOTE
• The PIC OFF indicator on the front of the Plasma Display
lights up in orange when the Picture off is selected.

No Signal off

The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Signal off" ( /
4
Select "Enable" ( /
Item
Disable
(factory default)
Enable
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Plasma Display after a TV
programme finishes.
32
En
then ENTER).
then ENTER).
then
Description
Does not decrease the picture brightness.
Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Decreases the picture brightness and lowers
power consumption.
Deactivates the screen to save power. To restore
the screen display, press any button other than
i +/i – and e.
This setting is not memorised by the system.
then ENTER).
then ENTER).
then ENTER).
Description
Does not place the system into the standby
mode.
Places the system into the standby mode if no
signal is received for 15 minutes.

No Operation off

The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Operation off" ( /
4
then ENTER).
Select "Enable" ( /
Item Description
Disable Does not place the system into the standby
(factory default) mode.
Enable Places the system into the standby mode if no
operation is performed for three hours.
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
then ENTER).
then ENTER).