Preparation; Installing The Plasma Display; Installing The Media Receiver - Pioneer PDP-436FDE Operating Instructions Manual

Preparation

Preparation

Installing the Plasma Display

Over 50 cm
Over
10 cm
Location
• Avoid direct sunlight. Maintain adequate ventilation.
• The length of the system cable used to connect the Plasma
Display and the Media Receiver is about 3 m.
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
CAUTION
• If you place anything on the top of the Media Receiver, it will
not receive enough ventilation and will not operate properly.
NOTE
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the
unit.
Using the optional PIONEER stand
For details on installation, refer to the instruction manual
supplied with the stand.
Using the optional PIONEER speakers
For details on installation, refer to the instruction manual
supplied with the speaker.
CAUTION
Operating Environment
Operating environment temperature and humidity:
+0 ºC – +40 ºC; less than 85 %RH (cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in locations
exposed to high humidity or direct sunlight (or strong artificial
light)

Installing the Media Receiver

Plasma Display
System cable
(approx. 3 m)
CAUTION
• Do not place a VCR or any other device on the top
of the Media Receiver.
• When installing, allow enough space on the sides
and above the Media Receiver.
• Do not block the side ventilation opening or the
rear exhaust opening of the Media Receiver.
ON STANDBY
STANDBY/ON
Over 5 cm
Ventilation
opening
CAUTION
Placing the Media Receiver alone in the vertical position can
result in product damage and malfunction.
Media Receiver
ON STANDBY
STANDBY/ON
Over 5 cm
PULL
OPEN
Over 5 cm
Over 10 cm
Exhaust
opening
05
PULL
OPEN
15
En