Routing Cables - Pioneer PDP-436FDE Operating Instructions Manual

Preparation
05

Routing cables

Speed clamps and bead bands are supplied for bunching cables. Once properly bunched, follow the steps below to route the
cables.
When the speakers are installed on the sides
Speaker cable
Attaching speed clamps to the main unit
Attach the speed clamps using the 2 holes marked with
below, depending on your routing system.
When the speakers are installed at the bottom (PDP-436FDE only)
NOTE
• Use the supplied bead bands as necessary.
18
En
Speed clamp
Cable binder (supplied
with the stand)*
SYSTEM
CABLE
WHITE
BLACK
Cable binders (supplied
Speaker cable
with the stand)*
SYSTEM
CABLE
WHITE
BLACK
Speed clamp
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the Plasma
Display and snap [2] into the back of [1] to lock the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
Use pliers to twist the clamp 90°, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
2
1
SYSTEM
CABLE
WHITE
BLACK
Speaker cable
* Cable binder
Using the cable binders supplied with the stand, put the
speaker and system cables together so that the cables are
invisible from the front. At that time be careful not to apply
any force to the connection sections of the cables.
(rear view)
Speaker cable