HIKVISION DS-2CD802PF-E User Manual page 32

31
User Manual of Network Camera
There are two network cards in the wireless IP camera: cable network card and wireless network
card. The default IP of the cable network card is 192.0.0.64 with 8000 as the default port, admin as
the administrator, and 12345 as the password. The wireless network card's default IP is
192.168.1.64.
If users configure the wireless parameters through client software, enter the remote setting
interface first. After entering the remote parameter settings interface, select "WiFi parameters"->
"WiFi Settings" to enter the WiFi settings interface, as shown in figure 3.5.2.
Figure 3.5.2 WiFi Settings Interface
In the WiFi settings interface, if user select Ad-Hoc mode as the operating mode, please set the PC's
wireless IP address in the same network segment as the IP address of wireless network camera.
Select "Manage Wireless Networks" in the computer's "Network and Internet". Find the device
which has the same name as the SSID number of the wireless camera. Then point-to-point
communication through wireless network is established successfully. So, there is no need to use an
Access Point (AP) between the PC and wireless network camera.
If users need to enable encryption, select the appropriate encryption type and set the
corresponding encryption parameters.
In the remote parameter settings interface, select "WiFi parameters"-> "Wlan Settings" to enter the
Wlan settings interface, as shown in Figure 3.5.3.