Ethernet Port (Eth0 To Eth16); Network Connection - Wieland wienet LMS 16-W User Manual

5.6.1

Ethernet Port (ETH0 to ETH16)

Panel socket RJ45. It is suggested to adopt ELA/TIA as the wiring of the RJ-45.
For RJ45 connectors, data-quality, twisted pair cabling (rated CAT5 or better) is recommended. The con-
nector bodies on the RJ45 Ethernet ports are metallic and connected to the GND terminal. For best per-
formance, use shielded cabling. Shielded cabling may be used to provide further protection.
Pin Signal
mark
1 TXD+
2 TXD-
3 RXD+
4 DC+
5 DC+
6 RXD-
7 DC-
8 DC-
Pin assignment RJ45-Plug
5.6.2

Network connection

wienet
The LMS 16-W switch has 16 x RJ-45 ports that support connection to 10 Mbps Ethernet, or
100 Mbps Fast Ethernet, and half or full duplex operation. The switch can be connected to other hubs or
switches through a twisted-pair straight through the cable or a crossover cable up to 100 m long. The
connection can be made from any TX port of the Switch (MDI-X) to another hub or switch either MDI-X
or uplink MDI port.The switch supports auto-crossover to make networking more easy and flexible. You
can connect any RJ-45 (MDI-X) station port on the switch to any device such as a switch, bridge or
switch.
12
Description
Transmit Data – positive pole
Transmit Data – negative pole
Receive Data – positive pole
POE power + (if POE is
equipped)
POE power + (if POE is
equipped)
Receive Data – negative pole
POE power - (if POE is equipped)
POE power - (if POE is equipped)
EIA/TIA-568B
EIA/TIA-568A
Data flow direction
Input/Output
Input/Output
Input/Output
Input/Output
1. White, Orange
2. Orange
3. White, Green
4. Blue
5. White, Blue
6. Green
7. White, Brown
8. Brown
1. White, Green
2. Green
3. White, Orange
4. Blue
5. White, Blue
6. Orange
7. White, Brown
8. Brown
Wieland Electric GmbH | BA001108 (Rev. A) | 01/2017
Ethernet connector