Summary of Contents for Wieland wienet WR-LAN v3 SL
Page 1
WR-LAN v3 SL Industry LAN router USER MANUAL Doc.-No. BA001037 Updatet: 08/2016 (Rev. A) Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
Page 2
COPYRIGHT This document is copyright-protected. The rights derived from this cop- yright are reserved for Wieland Electric GmbH. Reproduction of this document or parts of this document is only permissible within the lim- its of the statutory provision of the Copyright Act. Any modification or abridgment of the document is prohibited without the express written agreement of Wieland Electric GmbH.
Type tests and environmental conditions ............24 Technical parameters of WiFi ................25 Technical parameters of I/O port ................25 Other technical parameters .................. 25 Recommended Literature ................25 Troubleshooting ..................25 FAQ ......................26 Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
1 About this manual wienet Please read this section carefully before you use this manual and the Router from Wieland. Here you will find all the information required for commissioning and operation. Target groups and qualification of personnel Commissioning and installation of components for such types of installations must be considered.
Page 5
If it is in the proximity of TV sets, radio receivers and personal computers, the telephone may cause interference. • It is recommended that you should create an appropriate copy or backup of all the important • settings that are stored in the memory of the device. Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
At the end of it’s life this product MUST NOT be mixed with other commercial waste for disposal. Check the terms and conditions of your supplier for disposal information. Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
This allows mass reconfiguration of many routers in one time. Examples of possible applications • remote service on machines • mobile office • fleet management • security system • telematic • telemetric • remote monitoring • vending and dispatcher machines Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
• crossover UTP cable, • 2.4 GHz WiFi antenna (only for version with WiFi), • loose power and I/O connector • clip for the DIN rail, • installation instructions. • USB-Stick with documentation Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
Version with SWITCH board Version with SWITCH board & WiFi Version with SWITCH Version with SWITCH and WiFi 5.2 Delivery identification Trade name wienet Type name WR-LAN-v3-SL Other Router in metal box Label example Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
For correct function of the router we recommend to use it in a switch-board with earth-bonding distribu- tion frame for grounding of the power supply, of the router, the data cables and the antenna. Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
For removing from the DIN rail: 1. lightly push the router upward 2. fold out the top part of the router away from the DIN rail. Removing from the DIN rail Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
Connector for connection of USB devices to the router. Supports Host devices with PL-2303 and FTDI USB/RS232 converters. 6-pin Connector for connection of the binary inputs and output wienet WR-LAN v3 SL front panel Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
WR-LAN v3 SL can be put into "low power mode" using a special command. Then it can be awakened for example by an activity on binary input or using an internal timer. Circuit example: Connection of power supply Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
• After the click, release the card and it will pop out of its slot. • Remove the microSD card and push any other microSD card into the slot until it clicks in place. SD card Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
USB data - USB data signal – negative pole Input/Output USB data + USB data signal – positive pole Input/Output Negative pole of DC supply voltage Connection of USB connector USB connector Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
• Binary output parameters: Binary output connection with example: – 60 V AC/ 300 mA – 60 V DC/ 300 mA • Current of binary output is limited by a resettable fuse (300 mA). Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
Turn off and then turn on router Disconnect and connect the power, Press the Reboot button in the web configuration Reset Restore default configuration and Press RST button reboot the router Description of reset and restart router Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
The network cable is not connected State indication of the port: Ethernet interface, IEEE 802.3 standard Maximum data rate 100 Mbit/s Max. total cable length (300 Bd, 200 nF/km) 100 m Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
Before putting the router into operation it is necessary to connect all components which are required to run your applications. Note! N OT E The router can not operate without a connected power supply. Router connection Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
It is necessary to use the HTTPS protocol for secure communication over a network! AT TENT I ON Entering the IP address of the router Configuration may be performed only by the user "root" with default password "root". Entering login information Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
Page 21
After successfully entering login information user gains access to the router via his internet browser. Router web interface Note! N OT E A detailed description of the router settings via theWeb interface can be found in the document Configuration manual for v3 routers. Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
ETSI EN 300 328 v1.8.1 ETSI EN 301 489-1 v1.9.2, ETSI EN 301 489-12 v2.2.1, IEC 61000-6-2:2005, IEC 61000-6-3:2006 Safety EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013, EN 62311:2008 Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
Cold EN 60068-2-1 + 40 °C* * The temperatures are given for basic version of the router. For example, if the router is equipped with WiFi module, values are slightly worse. Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
• hand by selection of communication rates of 10 MB/s in property network cards, • connect router over switch, • start computer only after finalizing the start of the router. Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...
SMS messages do not change the router configuration. They remain in effect only until the router is restarted.. FTP doesn’t function. • Router doesn’t support active FTP mode. It supports passive mode only. Wieland Electric GmbH | BA001037 (Rev. A) | 08/2016...