Table of Contents
Advertisement
2. FRONT PANEL
TCG 01-G features two LED indicators on the front panel (Figure 2), together with a 2-line by 16-
character backlit LCD display.
SYN LED: This LED shows the status of the current sync source.
ALM LED: This LED shows the alarm status of the TCG 01-G.
LCD Display
On initial power-up, the LCD display shows a copyright message, along with the serial number and
revision level of the unit (Figure 3a). Approximately 10 seconds after power-up, the display changes
automatically to indicate that it is waiting for satellites (Figure 3b). Once one or more satellites have
been discovered, it transitions to the operating default display (Figure 3c). After which, the user can
access alternative time displays by pushing the button on the front panel between the LED
indicators, as shown in Figure 3d and Figure 3e. Successive button-pushes can be used to cycle
through all the display screens in turn. The screen display examples below all show the same instant
in time.
TEK-TCG 01-G-Manual-v5-092016
© 2016 by Tekron International Limited. All Rights Reserved. All trademarks are the property of their respective holders. The
information in this document is provided for informational use only and is subject to change. For further information or support, go to
www.tekron.com.
Figure 2 TCG 01-G front panel
TCG01G
Ver F01.XX
(C) 2014
Sn18748
3a Start Up (Clock ID)
UTC+1200
17MAR10
076
11:16:53
87A
3c Operating Default
UTC: MON 16 MAR10
075
23:16:53
87A
3e UTC Time
Figure 3 LCD display screens
WAITING FOR SATS
GNSS RX STAT: 00A
3b Waiting for Satellites
LST:
TUE 17 MAR10
076
11:16:53
3d Local Time
*** ANT ***
075
23:16:53
3f Alarm
P a g e
| 6
87A
87A
www.tekron.com
Advertisement
Table of Contents
